SET PROCESSING

        The  following  SET  Parameter  commands control data processing op-
    tions:
    LAS\SET ALIGN Type Range
    LAS\SET BAD Check
    LAS\SET BASE arg
    LAS\SET CALIBRATION [Beam_Tol [Gain_Tol]] or OFF
    LAS\SET MASK [ml1 ml2 [...]] [/VAR array]
    LAS\SET MATCH Tol
    LAS\SET NOMATCH
    LAS\SET TYPE CONTINUUM or LINE or SKYDIP
    LAS\SET VARIABLE Section_Name [Keyword]
    LAS\SET VELOCITY L[sr]H[eliocentric]A[utomatic]
    LAS\SET WEIGHT type
    LAS\SET WINDOW [wl1 wu1 [wl2 wu2 [...]]] -
                   [/POLYGON [N] [filename1...filenameN] [/VAR array]]