Next: SET FREQUENCY
Up: SET
Previous: SET FLUX
Contents
Index
SET FORMAT
CLIC\SET FORMAT Keyword [ON] [OFF]
Set the format of the header information listed with the LIST /LONG com-
mand. Each keyword indicate whether certain informations are to be writ-
ten (ON) or not (OFF). If all Keyword are ON, then the same list of in-
formation as with the command HEADER is obtained.
General information line (always written)
Observation number
Scan number
Project Id
Source name
Source type
Procedure name
Interferometer configuration
Date of observation
UT of observation
Hour angle
Position information line (keyword POSITION)
RA or L : right ascension or longitude (or azimuth)
DEC or B : declination or latitude (or elevation)
Epoch if equatorial coordinates are used
Offsets in current units
Type of coordinate (Eq, Ga, Ho)
Flux of the source
Quality information line (keyword QUALITY)
Quality code
Flag
Receiver number
Number of dump
Azimuth
Elevation
Spectral line information line (keyword STATUS)
Line name
Rest frequency
Sideband
Doppler correction
Source velocity
Quarter [for new receivers only]
Polarization [for new receivers only]
Narrow-band correlator input [for new receivers only]
Correlator information, for each subband (keyword SPECTRAL)
Logical name
Width (MHz)
Central IF (MHz)
Physical unit
Interferometer status, for each antenna (keyword INTERFERO)
Antenna number
Station
Pointing & Focus correction, for each antenna (keywrod POINTING)
Azimuth correction
Elevation correction
Focus correction
Calibration information, for each antenna (keyword CALIBRATION)
Receiver temperature (K)
Image rejection (dB)
Water (mm)
System temperature (Tsys)
Gildas manager
2014-07-01