SET TRIANGLE

        CLIC\SET TRIANGLE t1 t2 ...

    *** THIS HELP IS NOT UPTODATE ***

    Selects the triangle products for which data will be  displayed  by com-
    mand   PLOT.   Valid   triangles are codes as e.g. "123" or "345".  This
    command is exclusive with commands  SET  BASELINES  and SET  ANTENNAS.

    This command will be effective only if the triangle products  have  been
    computed  and  stored  in the data by commands SPECTRUM/TRIANGLE or COM-
    PRESS/TRIANGLE.  In that case the triangle products will have been aver-
    aged  by  these  commands;  since the phase of the triangle products are
    closure quantities, the amplitude of the average should not be  affected
    by atmospheric decorrelation.