SOLVE RF_PASSBAND

        CLIC\SOLVE RF_PASSBAND [da] [dp] [/PLOT]

    *** THIS HELP HAS NOT BEEN UPDATED FOR THE NGRX ***

    Solve  for  passband calibration curves, by fitting it to the amplitudes
    and phases. The current index should contain calibration observations of
    strong continuum sources (RF passband calibrator). The behaviour of this
    command depends on the current mode of RF passband calibration (Frequen-
    cy or Channel).

      -  For  frequency-dependent  RF  passabnd calibration (SET RF_PASSBAND
        FREQUENCY, recommended): the resolution is normally done  using  all
        the  spectral subbands plotted together, as a function of intermedi-
        ate frequency. It should be done separately for upper and lower side
        bands. A single frequency-dependent polynomial is fitted, a high de-
        gree might be necessary for the phase, if band edges are used (up to
        20 is feasible).

      - For channel dependent RF passband calibration (SET RF_PASSBAND CHAN-
        NEL)

        (i) For continuum, the data itself is directly stored as calibration
        values (this gives a channel-dependent passband curve).  In addition
        a polynomial is fitted and optionally plotted (this gives a frequen-
        cy-dependent passband curve).

        (ii) For spectral subbands, polynomials are  fitted  and  optionally
        plotted, as a channel-dependent passband curve.

    The degrees for polynomials are 'da' for amplitude, 'dp' for phase  (de-
    faults  0  and 1). Command STORE should be used next to store the fitted
    function in the header of source observations.  Both  channel  dependent
    and  frequency  dependent curves can be stored; Use command SET RF_PASS-
    BAND FREQUENCY|CHANNEL to apply one or the other.

    Option /PLOT will plot the polynomial fits over the data.