FEBE1 | S | ||
FEBE1%HEADER | S | ||
FEBE1%HEADER%ZFLXRX | R | deg | Pointing Coefficient (receiver), adds to ZFLX |
FEBE1%HEADER%ECECRX | R | deg | Pointing Coefficient (receiver), adds to ECEC (P8) |
FEBE1%HEADER%IERX | R | deg | Pointing Coefficient (receiver), adds to IE (P7) |
FEBE1%HEADER%CARX | R | deg | Pointing Coefficient (receiver), adds to CA (P2) |
FEBE1%HEADER%IARX | R | deg | Pointing Coefficient (receiver), adds to |
FEBE1%HEADER%FRQTHROW | R | Hz | Frequency switching throw |
FEBE1%HEADER%NPHASES | I | number of switch phases in a switch cycle | |
FEBE1%HEADER%SWTCHMOD | C*20 | Switch mode | |
FEBE1%HEADER%NUSEFEED | I | number fo feeds in use. | |
FEBE1%HEADER%FEBEFEED | I | total number of feeds. | |
FEBE1%HEADER%FEBEBAND | I | total number of basebands for this frontend-backend | |
combination | |||
FEBE1%HEADER%DEWANG | R | deg | dewar angle |
FEBE1%HEADER%DEWRTMOD | C*5 | dewar tracking system | |
FEBE1%HEADER%DATE_OBS | C*23 | observing date (Y2K format with time) in TIMESYS | |
system (scan start) | |||
FEBE1%HEADER%SCANNUM | I | scan number | |
FEBE1%HEADER%FEBE | C*17 | frontend-backend combination identification |
FEBE1%DATA | S | ||
FEBE1%DATA%GAINELE1 | ![]() |
deg | Gain-elevation correction parameter 1 |
(see MBFITS manual) | |||
FEBE1%DATA%GAINELE2 | ![]() |
deg | Gain-elevation correction parameter 2 |
(see MBFITS manual) | |||
FEBE1%DATA%GAINIMAG |
![]() |
Gain ratio image/signal sideband | |
FEBE1%DATA%FLATFIEL |
![]() |
receiver array flat field (relative gains) | |
FEBE1%DATA%BOLCALFC | ![]() |
Jy/counts | bolometer calibration factor |
FEBE1%DATA%ANTGAIN |
![]() |
K/Jy | Antenna gain |
FEBE1%DATA%HPBW |
![]() |
deg | Half-power beam width |
FEBE1%DATA%ETAFSS |
![]() |
forward efficiency | |
FEBE1%DATA%BEAMEFF |
![]() |
beam efficiency | |
FEBE1%DATA%APEREFF |
![]() |
aperture efficiency | |
FEBE1%DATA%POLA | ![]() |
deg | feed orientation |
FEBE1%DATA%POLTY | C*1 | feed type (X, Y, L, R) | |
FEBE1%DATA%REFFEED | I | feed number of reference feed | |
FEBE1%DATA%FEEDOFFX | ![]() |
deg | feed x offset |
FEBE1%DATA%FEEDOFFY | ![]() |
deg | feed y offset |
FEBE1%DATA%DATA%FEEDTYPE | ![]() |
feed type (see MBFITS manual) | |
FEBE1%DATA%USEFEED | ![]() |
list of feeds which are in use |