In the project account, the reports directory contains the first
calibration results produced or revised by the AoD
(Sect. ). The gzipped postscript and ascii files
report on the calibration. Particularly those whose names include -pipe result from the automatic data reduction or pipeline
(Sect.
). You will get familiar with the calibration
reports in Sects.
,
and
. The AoD performing the observations evaluates
the data quality and calibration, and may write notes in the ascii
file of extension note. It is recommended to read the notes
relative to each track before starting its calibration. The files of
extension hpb, so-called header files, store the
parameters derived from the calibration.
Having a look at the automatic reports before starting the calibration
may be useful, mainly for an experimented astronomer. They can be
used, for instance, to decide on the first track to calibrate, likely
the one with the best flux calibration. In addition, note that the AoD
at Bure performs a comprehensive analysis of the observations, and
his/her notes (in the note file) may be useful to identify
problems, which perhaps are visible in some of the plots of the First Look report (see Sect. and
App.
). Recommendations concerning the calibration might
also be added to the AoD notes.
Nowadays the pipeline is distributed with every release of GILDAS, although it can only be used with data obtained later than January 2007. You just need to type ``@pipeline `project_name' `date' '' and the pipeline will be launched, producing outputs very similar to those obtained at PdB. It has become usual among PdBI users to start the data calibration by launching the pipeline. If this first calibration is not satisfactory, the analysis of the pipeline report, with the help of the AoD notes and the local contact, allow improving easily the data calibration. Anyway, we recommend to have a critical look at the pipeline output protocols before making use of the hpb files. Particularly, it is known that the Data Quality Assessment procedure launched at the end of the calibration often flags out more data than actually needed. If you plan to recalibrate all or parts of the calibration from the pipeline-produced hpb file, we recommend first to remove all the Data Quality Assessment flags by using the following commands:
file both `file_name.hpb'
find store flag redu /ant all /reset store flag redu /base all /reset |
At the end of the new calibration you can use the Data Quality
Assessment procedure (Sect. ) to flag the
undesirable data according to the needs of your project.